Silencer Mod 2

I got from hardware store

It is an approx. 10mm wide, can pass as 9mm caliber replica! (Fake one, make believe)

Use HOT glue or "Goop" to hold the nut in place.

Place the two halves backs, use strong glue like super glue to steady the two into place.
If you are feeling "extra", sand the seams smooth & flush to be rid of the glue marks.
Use grade "320" sandpaper or fine metal file to do.

Any gaps, use modeling putty to fill the gaps. Again, sand the traces smooth after the putty has set.

The cap of the sliencer can taken over. Carefully pry it out.

An opened silencer.

Use HOT  glue or "Goop" to apply the insides.

Insert the Bolt into the silencer case before closing.

Adjust accordingly.
Wait 24 hours before following up on paint job.

Now the glue is 80% set.
Let's see if the idea works.

Screw in slowly

Sucess! It is in!